固定污染源廢氣 苯系物的測定，芝麻香白酒，3-甲硫基丙醇，室內空氣，焦爐煤氣，煉廠氣，變壓器油，多氯聯苯，植物油，6號溶劑殘留，裂解進樣器，三甲胺，二甲醚，乙縮醛，增塑劑...

固定污染源廢氣 苯系物的測定
固定污染源廢氣 苯系物的測定 詳細信息：

名稱：毛細管柱

固定相：聚乙二醇

規格：30m*0.53mm

型號：PEG-20M

應用：固定污染源廢氣 苯系物的測定 氣袋采樣 直接進樣-氣相色譜法

1 適用范圍

本標準規定了測定固定污染源廢氣中苯系物的氣袋采樣/直接進樣-氣相色譜法。

本標準適用于固定污染源廢氣中的苯、甲苯、乙苯、鄰二甲苯、間二甲苯、對二甲苯、異丙苯和苯乙烯的測定。

當進樣體積為 1.0ml時,苯、甲苯、乙苯、鄰二甲苯、間二甲苯、對二甲苯、異丙苯和苯乙烯方法檢出限為 0.2~0.6mg/m³,測定下限為 0.4~2.4mg/m³,詳見附錄 A。

2 規范性引用文件

本標準引用了下列文件或其中的條款。凡是不注日期的引用文件,其有效版本適用于本標準。

GB/T 16157 固定污染源排氣中顆粒物測定與氣態污染物采樣方法

HJ 732 固定污染源廢氣 揮發性有機物的采樣

HJ/T 397 氣袋法固定源廢氣監測技術規范

3 方法原理

用氣袋采集固定污染源廢氣中苯系物,取一定體積的樣品直接注入帶有氫火焰化檢測器 (FID)的氣相色譜儀中直接測定分析。根據保留時間定性,峰面積定量。

4 干擾和消除

樣品成分復雜時會對測定產生干擾,可以使用 GC/MS 定性確認。

5 試劑和材料

除非另有說明,分析時均使用符合國家標準的分析純試劑。

5.1 標準氣體:含有苯、甲苯、乙苯、鄰二甲苯、間二甲苯、對二甲苯、異丙苯、苯乙烯待測化合物的有證標準氣體,且鋼瓶壓力輸出為10MPa。

5.2 標準物質:苯、甲苯、乙苯、鄰二甲苯、間二甲苯、對二甲苯、異丙苯、苯乙烯,色譜純。

5.3 氮氣:純度≥99.99%。

5.4 氫氣:純度≥99.99%。

5.5 空氣:用凈化管凈化。

固定污染源廢氣 苯系物的測定 測試譜圖：


Stationary pollution source waste gas determination of benzene series
Stationary pollution source waste gas Determination of benzene series detailed information:

Name: Capillary Column

Stationary phase: polyethylene glycol

Specification: 30m*0.53mm

Model: PEG-20M

Application: fixed pollution source waste gas, determination of benzene series, air bag sampling, direct injection-gas chromatography

1 Scope of application

This standard specifies the air bag sampling/direct injection-gas chromatography method for the determination of benzene series in waste gas from stationary sources.

This standard applies to the determination of benzene, toluene, ethylbenzene, o-xylene, m-xylene, p-xylene, cumene and styrene in waste gas from stationary sources.

When the injection volume is 1.0ml, the detection limit of benzene, toluene, ethylbenzene, o-xylene, m-xylene, p-xylene, cumene and styrene is 0.2~0.6mg/m3, and the lower limit of determination is 0.4 ~2.4mg/m3, see Appendix A for details.

2 Normative references

This standard quotes the following documents or their clauses. For undated reference documents, their valid versions apply to this standard.

GB/T 16157 Determination of particulate matter in exhaust from stationary sources and sampling method for gaseous pollutants

HJ 732 Sampling of volatile organic compounds from stationary pollution sources

HJ/T 397 Airbag method fixed source exhaust gas monitoring technical specifications

3 Principles of the method

Use an air bag to collect the benzene series in the exhaust gas of a fixed pollution source, and take a certain volume of the sample directly into a gas chromatograph equipped with a hydrogen flame detector (FID) for direct measurement and analysis. Qualitative based on retention time and quantitative peak area.

4 Interference and elimination

Complicated sample composition will interfere with the determination, which can be qualitatively confirmed by GC/MS.

5 Reagents and materials

Unless otherwise specified, analytical reagents that meet national standards are used for analysis.

5.1 Standard gas: a certified standard gas containing benzene, toluene, ethylbenzene, o-xylene, m-xylene, p-xylene, cumene, styrene to be tested compounds, and the cylinder pressure output is guaranteed to be 10MPa.

5.2 Standard materials: benzene, toluene, ethylbenzene, o-xylene, m-xylene, p-xylene, cumene, styrene, chromatographically pure.

5.3 Nitrogen: purity ≥99.99%.

5.4 Hydrogen: purity ≥99.99%.

5.5 Air: Purify with a purification tube.



Stationary pollution source waste gas determination of benzene series test spectrum:

如果您覺得“PEG-20M毛細管柱 固定污染源廢氣 苯系物的測定”描述資料不夠齊全，請聯系我們獲取詳細資料。(聯系時請告訴我從給覽網看到的，我們將給您最大優惠！)
本頁鏈接：http://m.18bearing.com/com_haohanyiqi/sell/itemid-9050298.html
已經有915位訪客查看了本頁.